These AP have a interesting Console cable.
You need a special cable AIR-CONSADAPT=
Best to use a POE Adaptor so you get ethernet access for TFTP AIR-MOD-POE
Connect to POE port to power the device and issue this command on console
Enable
Username is Cisco
Password is Cisco
Enable
archive download-sw /reload tftp://x.x.x.x/SW1800-SENSOR-K9-2-3-6-0.tar.gz
Starting the image download...,
It may take a few minutes to finish download.,
If it is longer, please abort command, check network connection and try again
########################################################## 81.1%[*05/06/2023 07:46:36.1999] systemd[1]: Failed to start NTPD daemon.
[*05/06/2023 07:46:36.1999] systemd[1]: ntpd.service failed.
######################################################################## 100.0%
Image downloaded, writing to flash...
do PREDOWNLOAD, part1 is active part
Image signing verify success.
Verify returns 0
Unlocking /dev/mtd4 ...
Erasing /dev/mtd4 ...
23+0 records in
23+0 records out
upgrade.sh: part to upgrade is part2
upgrade.sh: AP backup version: 2.3.6.0
IPC socket server not ready for capwapd. Try after few moments, Errno: 2
do ACTIVATE, part1 is active part
upgrade.sh: activate part2, set BOOT to part2
upgrade.sh: AP primary version: 2.3.6.0
upgrade.sh: AP backup version: 8.8.259.0
Archive done.
Note: now login details
Username is sensor
Password is password
Wireless ONLY
Create SSID called CiscoSensorProvisioning (Hidden) WiFi Network with DHCP
No comments:
Post a Comment